If you see a digitizer's products for less at a different outlet, email us. We'll match the price!
NEED A DIFFERENT FORMAT?
We reformat free of charge (including ART or different format for a secon machine). If your format is not listed, order in PES and email us (be sure your hoop size is supported). NOTE: If you later need all previous purchases converted to ARTv4 - ARTv6, there is a $1 per set fee.
The horizontal design of this smart phone holder will make wearing it comfortable, even when in a sitting position. Itís been designed to be worn on a belt either by threading the belt through a loop on the back of the holder, or hanging it from an O ring and clasp. The Velcro closure is applied during the embroidery process and the holder is quilted in the hoop to provide some protection for the device. Personalize the holder with an initial as shown; our Ĺ inch Classic Block font was used on our sample. But you can also stitch the design without the monogram label.
There is a seam at the bottom of the lining that will need to be hand sewn or fused shut. There also is a very small amount of machine stitching to create the belt loop. The holder is completely lined and all seams are hidden.
This in-the-hoop project requires a 7x11 inch or larger hoop.
The holder can accommodate phones up to 3.00x6.00 inches. It can also serve as a billfold, coupon holder, etc. It can even hold a passport!
Finished holder size: 4.25x6.50 inch
FORMATS INCLUDED: ART DST EXP HUS JEF PES SHV VIP VP3 XXX
Design Dimensions and Stitch Counts: Lining 7.00x7.88 inch, 856 st. Pocket 7.00x3.20 inch, 2,329 st. Outside with label 7.00x7.88 inch, 5,133 st. Outside without label 7.00x7.88 inch, 4,811 st.